Water flow sensor consists of a plastic valve body, a water rotor, and a hall effect sensor - when water flows through, the internal rotator will change its speed with different rate of flow and hall effect sensor outputs the corresponding pulse signal. Use with laser cutters or CNC to measure if and how much water is flowing through laser tube or CNC spindle for cooling.

Specifications

Working Voltage: DC 5V~24V
Maximum Working Current: 15mA @ 5V DC
Flow Rate Range: 0.3~6L/min
Connection: 6mm (external diameter)
Inlet Water Pipe Diameter: 2.5-4mm
Load Capacity: ≤10mA (DC 5V)
Operating Temperature: ≤80℃
Liquid Temperature: ≤120℃
Operating Humidity: 35%~90%RH
Water Pressure: ≤2.0MPa
Storage Temperature: -25~+ 80℃
Storage Humidity: 25%~95%RH

Connections

Red: Power In
Black: Ground
Yellow: Signal Output

Write a review

Note: HTML is not translated!
    Bad           Good
Captcha

Water Flow Sensor YF-S401

0.3-6L/min
  • Product Code: Water Flow Sensor: YF-S401
  • Availability: In Stock
  • $5.95 USD


Related Products

Raspberry Pi GPIO Extension Board

Raspberry Pi GPIO Extension Board

with Ribbon Cable

Raspberry Pi GPIO Extension Board with Ribbon Cable Raspberry Pi dedicated GPIO adapter with 3.3V/..

$0.95 USD $4.95 USD

Inductive Proximity Sensor PL-05N

Inductive Proximity Sensor PL-05N

For Laser or CNC Machines

PL-05N Inductive Proximity Sensor 5mm NPN Output 10-30v Inductive Proximity Sensor PL-05N NPN&..

$7.99 USD

DHT22 Digital Temperature & Humidity Sensor

DHT22 Digital Temperature & Humidity Sensor

Temperature & Humidity

The DHT22 is a accurate digital temperature and humidity sensor. It uses a capacitive humidity senso..

$5.00 USD

Temperature Control Thermostat Switch

Temperature Control Thermostat Switch

60C - 140F

Widely used for temperature control or protection for household electric appliances. It is open unti..

$0.95 USD

Tags: flow sensor, hall effect, arduino, water, 0.3l, 6l/min, sensor, laser cutter, cnc sensors yf-s401